Subaru Conversions

Crank Seal Subaru Flywheel End: Viton

This crank seal is Viton and will outlast the original 3-4 times.These are the only type of seal we'll use, and they're not easily replaced. Fitment Notes:1990-2008 normally aspirated Subaru engines: 1.8, 2.0, 2.2, 2.5, 3.0, and 3.3L Sold indivually. One...

SCP

Stainless Steel Exhaust "J" Pipe

Finally! A stainless steel version of the stock Vanagon collector to catalytic converter pipe. This has loose flanges on both ends and when used with the OE metal o-ring (linked below), it allows more flexibility in muffler and catalytic...

SCP

Subaru-Vanagon SVX 3.3L Parts Kit: M/T Vanagons & Syncros

A complete kit of parts to convert your Vanagon to a smooth, powerful Subaru SVX 3.3L powerplant. This kit is a matched and proven kit of parts that takes the worry out of building a Subaru powered Vanagon. No scouring the internet, fabricating parts, or...

SCP

Vanagon Basic Conversion Kit: A/T

Basic Conversion Parts Kit for Water Cooled ('83.5-'91) Automatic Transmission Vanagons Already have some of your own parts and just need a more "basic" conversion kit? With SCP's Basic Conversion Kit you're still receiving a matched and proven set...

SCP

Vanagon Basic Conversion Kit: M/T & Syncros

Basic Conversion Parts Kit for Water Cooled ('83.5-'91) Manual Transmission Vanagons & Syncros Already have some of your own parts and just need a more "basic" conversion kit? With SCP's Basic Conversion Kit you're still receiving a matched and...

ScanGauge

Cable Extension for ScanGauge

If your OBD2 connector is in the rear and more than six feet away from the dash, this extension cable adds another 20 feet to your cable. In Vanagons this allows you to keep all connections inside the vehicle and out of the elements.Includes necessary...

Subaru

Subaru Crank Seal: Viton

Not to be confused with other brands. Viton Crank Seals will outlast the stock Subaru ones by three to four times. Viton Crank Seals are the only seals we'll use for this area that is prone to leakage.Fitment Notes:1990-2008 normally aspirated Subaru...

Coolant pipe stainless

This heliarc welded stainless coolant pipe is designed to go across the back and the right side of the Vanagon engine bay to allow easy connection of the Subaru coolant outlet to the Vanagon radiator pipe. No coolant manifold alterations are needed when...

Intake Manifold Gasket: Subaru 1999-Later

These intake gaskets should be replaced whenever the intake manifold is removed and reinstalled.Fits the following Subaru engines:2.2L: 1999-2001 Legacy 2.5L Non-Turbo: 1999-2009 Forester 2.5L Non-Turbo:1999-2010 Impreza 2.5L Non-Turbo:1999-2011 Sold as...

Subaru

Piston Ring Set 2.5L SOHC Subaru

We have been able to source Subaru rings from the OE manufacturer. We guarantee these rings to be equal to the original replacement rings and to incorporate the latest design specifications. This set fits the following engines: Subaru Baja 2003-2006 2...

Hose Menders: Brass

These durable hose menders are useful for various tasks in an engine conversion.Sizes available are as follows:8 x 8mm: useful for splicing fuel hoses - especially for a Syncro Vanagon5/8" x 5/8": for splicing heater hoses - in front or rear.3/8" x 1/2":...

Vanagon Coolant Reservoir Tank: 1986-1991

Good quality made tank with Blau German Reservoir Cap. This is a reproduction of the stock Vanagon 1986-1991 coolant reservoir tank. Required when using our coolant reservoir bracket with a 1980-1985 Vanagon conversion.

SCP

Subaru EJ22 Power Steering Hose Kit

This hose connects the Subaru power steering pump to the power steering rack on the right side of the engine compartment. Works with four or six cylinder Subaru engines. Some EJ22 power steering pumps have 14 mm outlets and some have 16 mm outlets...

Accelerator Cable Kit: Manual Transmission: 8mm

This kit is a complete replacement of the stock manual transmission accelerator cable and includes all parts to connect the Subaru engine to the accelerator pedal. Fitment Notes: 1990-1994 Subaru engines and the SVX have a 6mm barrel at the throttle...

SCP

Tachometer Unit Calibration

The Subaru engine's ECU has a tach output. However, the late model ('86-'91) Vanagon's tachometer is not sensitive enough to pick up this signal. Lucky for you we have a solution! We have altered the circuitry in the tachometer to increase the...

SCP

Vanagon Gauge Face Set (White) - 7K PRM

These white overlays are applied over your original faceplates and are available with a 7,000 or 8,000 max RPM tachometer. All attachment points are precision cut to match your original stock gauges.   Installation Instructions

SCP

Vanagon Gauge Face Set - 8K rpm white

These very nice white overlays are applied over your original faceplates and are available with 7,000 or 8,000 max rpm tachometer. Ours have the tiny square openings for the regular and trip odometers precut as are the fuel and temp gauge faces. Now...

Hall Effect Sensor

Replacement sensor for our Hall Effect Speed Sensor Kit. Installation Instructions

SCP

Steel Skid Plate Extension: 16"

16" metric steel addition to extend the Syncro skid plate rails for 3.3L Subaru engine conversions.

SCP

Skid Plate Extension Steel - 6"

Metric steel to extend the Syncro skid plate rails.6" is enough for one Vanagon with a 4cylinder engine.

SCP

Interface Board Deluxe

The Small Car Performance Interface Board Deluxe is designed to make a seamless 1996 and later Subaru installation with minimal engine codes, a working tach, an accurate temp gauge, and a functional neutral switch system. Installing our Interface Board...

SCP

Subaru 3.3L to Syncro Vanagon Engine Mount Adapter

The Small Car mount fits the 3.3L Subaru engines perfectly and has been designed and manufactured for 2WD Vanagons or Syncros. Our mount has the advantage of placing the stock Vanagon rubber mounts at the rear of the engine which drastically reduces...

SCP

Subaru 3.3L to 2WD Vanagon Engine Mount Adaptor

The Small Car mount fits the 3.3L Subaru engines perfectly and has been designed and manufactured for 2WD Vanagons or Syncros. Our mount has the advantage of placing the stock Vanagon rubber mounts at the rear of the engine which drastically reduces...

SCP

Tachometer Face (Black) 8K RPM

8,000 RPM tachometer face with precut shape and mounting holes. Also available in 7,000 RPM (shown). Installation Instructions