T3 Vanagon Parts 1980-1991

SCP

Vanagon Stainless Steel Exhaust with Stainless Steel Catalytic Converter

Need your entire exhaust system replaced? This complete stainless exhaust system is designed to fit just like the original VW parts but perform better and sound quieter than other OEM replacements. Kit Includes: Stainless Steel Muffler Stainless Steel...

Stainless Steel Tail Pipe: Vanagon & Type II

Tired of your VW Bus or Vanagon's tailpipe rusting out or drooping at a wierd angle? This polished stainless tailpipe is mandrel bent and has a loose flange design allowing the installer to angle the tip for any Vanagon or Type II model. Fits all years...

Performance Clutch Kit: SVX 5 Speed

This performance clutch kit is the best we've found for the SVX 5 speed conversion. We tried clutches from ACT, Clutchmasters, and a few others and found the pedal pressure to be excessive as well as other problems.You will like the feel and the...

SCP

Vanagon Stainless Steel Exhaust (Subaru or WBX)

  Need your entire exhaust system replaced? This complete stainless exhaust system is designed to fit just like the original VW parts but perform better and sound quieter than other OEM replacements.   Kit Includes: Stainless Steel...

Stainless Steel Vanagon Muffler: 1986-1991

This stainless-steel muffler is designed to fit just like the stock VW muffler. It’s multi-chamber design allows for better flow while still be relatively quiet. Over the years, we’ve found a large variation in the noise level with new stock...

16" Steel Wheel

What a fantastic combination! A tough 16" x 6.5" steel wheel that pairs well all season tires. The wheels are super heavy duty 4-4.5mm thick steel and are a 41mm offset which fits nicely on a 2WD or a Syncro Vanagon. They fit with all available brake...

SCP

Subaru 4 Cyl-Vanagon 4WD Engine Mount Powder Coated

New! Improved design for late Subaru engines - provides more clearance for thermostat housing and water pump. Our mount has the advantage of placing the stock Vanagon rubber mounts at the rear of the engine which drastically reduces engine movement and...

Crank Seal Subaru Flywheel End: Viton

This crank seal is Viton and will outlast the original 3-4 times.These are the only type of seal we'll use, and they're not easily replaced. Fitment Notes:1990-2008 normally aspirated Subaru engines: 1.8, 2.0, 2.2, 2.5, 3.0, and 3.3L Sold indivually. One...

SCP

Stainless Steel Exhaust "J" Pipe

Finally! A stainless steel version of the stock Vanagon collector to catalytic converter pipe. This has loose flanges on both ends and when used with the OE metal o-ring (linked below), it allows more flexibility in muffler and catalytic...

SCP

Subaru-Vanagon SVX 3.3L Parts Kit: M/T Vanagons & Syncros

A complete kit of parts to convert your Vanagon to a smooth, powerful Subaru SVX 3.3L powerplant. This kit is a matched and proven kit of parts that takes the worry out of building a Subaru powered Vanagon. No scouring the internet, fabricating parts, or...

SCP

Vanagon Basic Conversion Kit: A/T

Basic Conversion Parts Kit for Water Cooled ('83.5-'91) Automatic Transmission Vanagons Already have some of your own parts and just need a more "basic" conversion kit? With SCP's Basic Conversion Kit you're still receiving a matched and proven set...

SCP

Vanagon Basic Conversion Kit: M/T & Syncros

Basic Conversion Parts Kit for Water Cooled ('83.5-'91) Manual Transmission Vanagons & Syncros Already have some of your own parts and just need a more "basic" conversion kit? With SCP's Basic Conversion Kit you're still receiving a matched and...

SCP

Front Big Brake Upgrade Kit: Syncro

Want safer, modern, more reliable brakes for your Vanagon?   To be blunt, the stock Vanagon brakes are barely adequate if you have a 2WD passenger van with stock tires, good pads and shoes. If you have a Syncro, a Westfalia, or especially a...

ScanGauge

Cable Extension for ScanGauge

If your OBD2 connector is in the rear and more than six feet away from the dash, this extension cable adds another 20 feet to your cable. In Vanagons this allows you to keep all connections inside the vehicle and out of the elements.Includes necessary...

Subaru

Subaru Crank Seal: Viton

Not to be confused with other brands. Viton Crank Seals will outlast the stock Subaru ones by three to four times. Viton Crank Seals are the only seals we'll use for this area that is prone to leakage.Fitment Notes:1990-2008 normally aspirated Subaru...

Stainless Steel Brake Front Brake Dust Shields

Have your factory front brake dust shields rusted away to dust? Or perhaps your mechanic removed them during your last brake job and your brakes are just flying down the road unprotected? Or maybe you've purchased a SCP Front Brake Upgrade...

Coolant pipe stainless

This heliarc welded stainless coolant pipe is designed to go across the back and the right side of the Vanagon engine bay to allow easy connection of the Subaru coolant outlet to the Vanagon radiator pipe. No coolant manifold alterations are needed when...

Intake Manifold Gasket: Subaru 1999-Later

These intake gaskets should be replaced whenever the intake manifold is removed and reinstalled.Fits the following Subaru engines:2.2L: 1999-2001 Legacy 2.5L Non-Turbo: 1999-2009 Forester 2.5L Non-Turbo:1999-2010 Impreza 2.5L Non-Turbo:1999-2011 Sold as...

Subaru

Piston Ring Set 2.5L SOHC Subaru

We have been able to source Subaru rings from the OE manufacturer. We guarantee these rings to be equal to the original replacement rings and to incorporate the latest design specifications. This set fits the following engines: Subaru Baja 2003-2006 2...

Nylon Hose Adapters

These nylon 12 mm or 1/2" hose fittings are very useful when connecting the Subaru engine breather hoses.For those working on later Subaru engines, you will find that there are too many engine hoses and not enough fittings at the filter housing. Also,...

Hose Menders: Brass

These durable hose menders are useful for various tasks in an engine conversion.Sizes available are as follows:8 x 8mm: useful for splicing fuel hoses - especially for a Syncro Vanagon5/8" x 5/8": for splicing heater hoses - in front or rear.3/8" x 1/2":...

Fuel Hose Crimp Clamp

These OE stainless steel crimp clamps wrap your fuel hose one and one half times around so there is no pinched hose and little chance of fuel leakage. Why trust your Vanagon or your life to anything less?Choose the size to match fuel hose type:8.8-10...

Fuel Injection Fuel Hose: 5/16"

This 5/16" fuel hose fits the Subaru and the Vanagon fuel fittings. Sold per inch so you can order order the exact length you need. For the safest fuel line connections we recommend you use our fuel hose crimp clamps. Make sure to properly...

Westfalia Stove Knob - Gray

Replacement knobs for the Westfalia Stove are no longer available from VW. These gray replacement knobs are installed with a set screw, matching the later gray interior very well.  Sold each although a pair is recommended so they match.