Conversion Parts: 2.2L/2.5L

Why should you buy our parts?
 
  • We install, service, and personally use what we sell. After building over 300 Subaru powered Vanagons, we have learned a lot about how to make them run well. From cooling systems to wiring harnesses, we have designed our products to get your Vanagon conversion up and running quickly and keep it performing well for years.
  • Our parts allow you to install a Subaru engine and lose nothing of the original Vanagon's utility and great design. This includes having great ground clearance without the exhaust and other components hanging down below the engine, the ability to refit the Syncro skid plate, and built-in support for the muffler. 
  • Our cooling system has been refined to perform better than anything else available. Simple, easy to bleed, and a heater system that works at least as well as the original. 
  • It can be difficult to find all the right parts to make your Subaru powered Vanagon come to life. When you purchase our parts, we help your project come together quickly and successfully. For those who choose to buy a complete package from us, expect prompt, accurate replies to your questions. No one else offers anything close in design, performance and support.
$279.95
This gear reduction starter provides higher cranking torque and draws less current. This is especially helpful with any of the Subaru engines. Fits...
In stock
+

$27.50
Specifications: 2" aluminized 3" radius 180 degree mandrel bend
In stock
+

$12.95

Clutch Pilot Bearing for Smallcar Bellhousing

In stock
+

$129.95
Subaru's variable valve timing engine does not have a fuel pressure regulator attached to the fuel rail. Consequently, a regulator is needed to achieve the...
In stock
+

$1,495.00
This Harness and ECU modification is for the following Subaru engines: Legacy 2.5L normally aspirated 2010-12     Harness...
In stock

$65.00
Use this kit with the original Vanagon cable bracket to mount the Subaru drive by wire pedal on the firewall of a 2WD manual transmission Vanagon....
In stock

$16.00
Replacement sensor for our Hall Effect Speed Sensor Kit. Installation Instructions
In stock
+

$98.95
Use this kit to mount the Subaru drive by wire pedal behind the passenger side tail light.   Application & Fitment Notes: 2WD &...
In stock

$299.00
This is a remanufactured universal manual transmission Subaru starter that fits with SCP's bellhousing. Specifications: 1.3Kw Nine...
In stock
+

$59.95
All the OBD2 engines from 1996 on require a vehicle speed sensor. The engines up to 1995 will also idle and perform  better with one installed. This hall...
In stock

$324.99
Front to back radiator coolant pipe set in stainless steel for 1986-91 Vanagon Syncro.
In stock
+

$324.99
Front to back stainless steel coolant pipe set.   Fitment: 2WD Late Model (1986-1991) Vanagons SCP Subaru Vanagon Conversions
In stock
+