Basic 5-Speed Kit - SVX

5SPDKITBASE
*Call For Availability
$379.95

Our kit comes with all the specialized parts we use to convert an SVX to a five speed. The installation time is approximately 30-40 hours for a competent mechanic doing his first installation. There is some welding and a fair amount of cutting, fitting as well as wiring. Instructions are included with necessary wiring diagrams and templates With the help of this kit, most installers will be able to have a much better looking and better operating 5 speed than if they were to fabricate the parts themselves.

The kit is designed to use a transmission from a 2.5L or a WRX with a hydraulic clutch mechanism. Most all the parts will work for the cable clutch transmissions but the instructions do not cover all aspects of that conversion.

Click here for a digest of the instructions.

Included in the kit

  • Shifter plate lower
  • Driveline spacer
  • Tubing to lengthen Linkage
  • Screws for Plate (self tapping)
  • Speed nuts for console
  • Screws for console
  • Steel plate for front mount bracket
  • L brackets for front transmission mount
  • Bolt, nuts and washers at L brackets
  • Accelerator pedal adaptor plate
  • Screw for accelerator adapter plate
  • Steel plate for pedal assembly
  • Firewall plate for clutch master cylinder
  • Grommet for firewall
  • Instructions with templates

Parts you might want to buy new

Recommended Tools

  • Basic hand tools
  • Torque wrench
  • Drill motor & bits
  • Cutting and grinding tools
  • Wire crimper
  • Hot glue gun
  • Metal cutting saw (sawzall, sabre saw)
  • Fine bladed saw (for modifying plastic shifter trim plate)
  • Welder (wire feed works best)
  • Repair manual

Parts needed from the donor vehicle - Legacy, Forester, Impreza

We recommend any transmission from a 2.5L Subaru (these have the hydraulic clutch) Pedal Assembly Complete

  • Clutch Slave Cylinder w/banjo bolt
  • Clutch Master Cylinder
  • Master to slave hydraulic line and hose
  • Starter
  • Starter bolts
  • Transmission
  • Transmission to engine mounting bolts
  • Rear differential (not needed with WRX transmission)
  • Shift Linkage W/Plate and rear support
  • Shifter with knob
  • Shift Boot and Plate
  • Transmission mount W/Frame
  • Transmission Mount Rubbers, Plates
  • Exhaust hanger at rear of trans with bolts (WRX donor needs part from another model)
  • 2 Clutch Switches with Connectors and 8" Wire
  • Shift Bushings and Pin at Transmission
  • Axles (Needed only for some transmissions built after 2003)
  • Flywheel and flywheel Bolts
  • Release Bearing Arm (Hydraulic type)